Elite Access Systems Inc. part of The Chamberlain Group, Inc. Gate Operators
R&S
Motor Operators, Service Door Motors, Jackshaft Operators, Belt Drive Hoist Operators and Gear Drive Hoist Operators
 |
133 South Linden Ave. So San Francisco, CA 94080
phone: 650 873 - 7701 | fax: 650 873 - 7702 | Lic# 708345
|
 |
 |
| |
        
 |
|
|
Motors
Whether it is for a gate, grille, counter door, commercial sectional, steel rolling or automatic personnel door R&S offers the right choice for your operator.
|
Service Door Operators | Horsepower Selection Guide | Gate Operators
Service Door Operators:
'J' Belt Drive Jackshaft Operator
'H' Belt Drive Hoist Operator
'MG' Gear Drive Hoist Operator
'GJ' Gear Drive Jackshaft Operator
Features
- All models U.L. listed
- 115/230 volt - 1 phase or 208/230/460 volt - 3 phase
- Full overload protection
- Heavy duty reversing controller
- Instant reverse motor wiring on single phase
- 3-button NEMA 1 control station
- 24 volt control circuit
- Heavy duty driven limits
- Right or left hand / brackets or wall mount
- MG operators available with solid state controller
- Wired standard with constant pressure to close
- 12 month warranty at time of purchase
| Options
- Pneumatic or electric edge to provide safety stop or reverse upon contact with obstruction
- Keyswitch, ceiling pull switch, card key and keyless entry
Timer and photo electric control, loop detectors and treadles
NEMA 4, 7, 9, 12 / JIC and Car Wash modifications - Consult factory for other wiring modification, controls and accessoris
|
|
'J' Belt Drive Jackshaft Operator |
 |
'H' Belt Drive Hoist Operator |
For use on small rolling doors and small to medium size rolling grilles in standard usage applications.
Floor level disconnect for manual push-up operation.
Heavy duty V-belt drive with adjustable friction clutch and posi-lock brake system.
Available in 1/3, 1/2, and 3/4 horsepower.
Compatible with Emergency Egress System (See Aluminum Grille Options)
< back to top
|
|
For use on small to medium size rolling doors and all rolling grilles in standard usage applications.
Floor level disconnect with electrical interlock for manual chain hoist operation.
Heavy duty V-belt drive with adjustable friction clutch and posi-lock brake system.
Available in 1/3, 1/2, and 3/4 horsepower
|
'MG' Gear Drive Hoist Operator |
|
'GJ' Gear Drive Jackshaft Operator |
For use on all rolling doors and grilles in standard usage or high-cycle applications.
Floor level disconnect with electrical interlock for manual chain hoist operation.
Heavy duty bronze gears running in oil bath.
Electric solenoid brake
Available in 1/2, 3/4, 1, 1/2, 2 and 3 horsepower.
< back to top
|
|
For use on small rolling doors and grilles and all counter and counter fire doors
Adjustable torque limited with disconnect for manual push-up operation
Bronze gears running in oil bath
Compact belt drive jackshaft operator with 1 button control (Model SJ) is also available for use on counter and small rolling grilles in limited usage applications (115 volt - 1 phase only)
|
Horsepower Selection Guide For Rolling Doors and Grilles:
Model |
HP |
Maximum Square Footage |
24 GA |
22 GA |
20 GA |
18 GA |
Insu-lated |
Steel Grille |
Alum. Grille |
Steel Counter Shutter |
Alum. Counter Shutter |
LH LJ |
1/2 |
190 |
165 |
150 |
-- |
-- |
180 |
250 |
165 |
210 |
SJ |
1/2 |
-- |
-- |
-- |
-- |
-- |
120 |
140 |
100 |
135 |
GJ |
1/2 |
135 |
125 |
120 |
-- |
-- |
135 |
160 |
125 |
140 |
H J |
1/3 |
210 |
190 |
175 |
130 |
100 |
210 |
265 |
190 |
220 |
1/2 |
275 |
250 |
225 |
170 |
130 |
260 |
350 |
250 |
|
3/4 |
340 |
310 |
290 |
215 |
165 |
340 |
450 |
|
|
MG |
1/2 |
290 |
260 |
240 |
190 |
150 |
280 |
400 |
|
|
3/4 |
370 |
320 |
300 |
240 |
180 |
375 |
550 |
|
|
1 |
440 |
360 |
340 |
270 |
200 |
480 |
640 |
|
|
11/2 |
-- |
460 |
430 |
360 |
260 |
620 |
|
|
|
2 |
-- |
-- |
560 |
480 |
350 |
|
|
|
|
3 |
-- |
-- |
840 |
700 |
520 |
|
|
|
|
5 |
-- |
-- |
1200 |
920 |
780 |
|
|
|
|
71/2 |
-- |
-- |
1500 |
1100 |
950 |
|
|
|
|
Notes:
(1) Use 24 GA limits for aluminum service door.
(2) GJ, SJ, and LJ operators not recommended for use on doors/grilles too large to be manually operated. (Use MG, H, or LH on doors requiring manual hoist chain.)
(3) LH or LJ operators are limited to 10 complete cycles per hour.
(4) This chart is intended as a guideline only. Doors and balance springs musts be in good operating condition and adjusted to manufacturers specifications.
(5) The chart is based on door travel of approximately 2/3 foot per second. Doors traveling in excess of 2/3 foot per second will require increased HP rating or decreased maximum sq. ft. rating.
(6) High cycle may require upgraded operator. |
< back to top
Gate Operators
Once you have the gate, the next step is selecting the automatic gate operator that best suits the weight of the gate and the number of cycles it will be asked to perform per day. We carry Elite Access Systems Inc. gate operators with a model to suit your requirments: from low cycle home use gate operators to high traffic commercial gate operators. Elite Access Systems is part of The Chamberlain Group, Inc., the world´s largest manufacturer of residential and commercial door operators, access control products and gate operators. Chamberlain provides the broadest line of perimeter access control products for use in the residential, commercial and institutional markets.
Please Note -
For motors on residential gate installation and service - please contact:
R&S of San Mateo County, Inc.
1540 Gilbreth Rd. Burlingame, CA 94010 phone (650) 552-0660 fax (650) 552-0664
Operator Models :
Miricale One | RoboSlide | RoboSwing R900 | CSW200UL | SL3000UL | Hercules |
Miricale One
|
|
RoboSlide
|
Electromechanical Linear Gate Operator
Linear mechanical, 24 volt DC gate operator. It uses a precise limit switch system that reduces stress and creates a consistantly smooth operation.
|
12V DC Residential Slide Gate Operator
Uses only a 12 volt, battery system that can be charged either through the solar panel or plug in transformer.
|
RoboSwing R900
|
|
CSW200UL
|
Residential Swing Gate Operator
Uses only a 12 volt, 7 amp hour battery that can be charged either through the solar panel or plug in transformer.
|
High Traffic Commercial Swing Gate Operator
Commercial Swing Gate operator for use in high traffic applications, our most popular swing gate operator.
|
SL3000UL
|
|
Hercules
|
High Traffic Commercial Slide Gate Operator
Commercial Slide Gate Operator (1/2 HP) for use in high traffic applications. Capable of continuous cycles daily.
|
|
Commercial Overhead Gate Operator
Designed for 8´ overhead gates, the smartest choice for low clearance high traffic underground parking garages.
|
|
|
|
|
|
|
 |
 |